Print Back
Unit of Measure

Specifications

Available

N/A {0}

Manufacturer Stock

N/A {0}

Brands

N/A APEM

Manufacturer

N/A APEM

Series

N/A Q6

Mounting Hole Diameter

N/A 6 mm

Bezel Style

N/A Prominent

Terminals

N/A Solder Lug/Fastons (2.0 x 0.5)

Bezel Finish

N/A Bright Chrome

Type of Illumination

N/A Bi-Color

Note for Type of Illumination

N/A Bi-color - The color is changed by reversing the polarity of the supply voltage.

Light Emitting Diode (LED) Color

N/A Green Red

Direct Current (DC) Voltage

N/A No resistor

Sealing

N/A Ingress Protection (IP67)

Operating Direct Current (DC) Voltage

N/A 1.8 to 3.3 V

Maximum Operating Direct Current (DC)

N/A 20 mA

Note for Operating Direct Current (DC)

N/A Customer to supply resistor for desired operating current.

Electrical Specifications

Red Color Prominent Intensity

N/A 20 mcd

Green Color Prominent Intensity

N/A 10 mcd

Red Color Flush Intensity

N/A 15 mcd

Green Color Flush Intensity

N/A 8 mcd

Red Color Forward Voltage

N/A 2 V

Green Color Forward Voltage

N/A 2.2 V

Environmental Specifications

Operating Temperature Range (Rear Plastic Body)

N/A -30 to 65 ºC-22 to 149 ºF

Operating Temperature Range (Rear Epoxy Body)

N/A -40 to 85 ºC-40 to 185 ºF

General Specifications

Maximum Reverse Voltage (VR)

N/A 5 V
Viewing Angle1 N/A 30 to 100 º

Torque

N/A 4 cNm

Maximum Panel Thickness

N/A 7 mm

Materials

Material

N/A Plated brass bezel finished in bright chrome, black or satin gray and molded polycarbonate rear body

Features

Features

N/A
  • 3 mm colored diffused epoxy lens or 3 mm water clear super bright LEDs
  • Prominent, recessed and flush bezel styles
  • (2.0 x 0.5) solder lug terminals, pins or (200 mm long) wire terminations, other lengths available on request

Note

Note

N/A The company reserves the right to change specifications without notice.

All LED characteristics are dependent upon environmental conditions. Therefore published data should be considered nominal and subject to variations.
  • The operating voltage must not be exceeded by more than 10% as this will result in reduced life expectancy.
  • Luminous intensity is measured at 20 mA on a discrete led unless otherwise stated.
  • Luminous intensities and color shades of white LEDs may vary within a batch.
  • Luminous intensity will be reduced with lower operating current.
  • 1 Dependent on model