Unit of Measure

Specifications

Available

N/A {0}

Manufacturer Stock

N/A {0}

Brands

N/A APEM

Manufacturer

N/A APEM

Series

N/A QRM6

Mounting Hole Diameter

N/A 6 mm

Terminals

N/A Wires

Bezel Finish

N/A Black Chrome

Type of Illumination

N/A Fixed Light

Light Emitting Diode (LED) Color

N/A Green

Electrical Specifications

Direct Current (DC) Voltage

N/A No resistor

Sealing

N/A Standard Ingress Protection (IP67) EN60529

Operating Direct Current (DC) Voltage

N/A 1.8 to 3.8 V

Maximum Operating Direct Current (DC)

N/A 20 mA

Note for Operating Direct Current (DC)

N/A Customer to supply resistor for desired operating current.

Standard Light Emitting Diode (LED) Intensity

N/A 45 mcd

Green Color Forward Voltage

N/A 2.2 V

Environmental Specifications

Operating Temperature Range

N/A -40 to 85 ºC-40 to 185 ºF

Storage Temperature Range

N/A -55 to 100 ºC-67 to 212 ºF

General Specifications

Maximum Reverse Voltage (VR)

N/A 5 V

Viewing Angle

N/A 60 º

Life Expectancy

N/A 100000 hours

Maximum Panel Thickness

N/A 3.5 mm

Torque

N/A 60 cNm

Insulation Resistance at 500 Volt (V) Direct Current (DC) Voltage

N/A 4000 MΩ

Salt Spray Test

N/A 96 Hours (h) (International Electrotechnical Commission (IEC 68-2-11))

Materials

Body Material

N/A Anodized Aluminum Black Plated Brass

Lock Washer Material

N/A Spring Steel

Nut Material

N/A Black Plated Brass

Terminal Seal Material

N/A Epoxy

Panel Seal Material

N/A Nitrile O-Ring

Wires Material

N/A 24 American Wire Gauge (AWG) Approved to Underwriter Laboratories (UL1061) or (UL1213) on request

Features

Features

N/A
  • 3 mm flush diffused LED, standard, hyper bright or clear water
  • Bi-color LED options
  • 200 mm wire or pin terminations

Note

Note

N/A The company reserves the right to change specifications without notice.

LED characteristics are dependent upon environmental conditions. Therefore published data should be considered nominal and subject to variations.
  • The operating voltage must not be exceeded by more that 10% as this will result in reduced life expectancy.
  • Luminous intensity is measured at 20 mA on a discrete led unless otherwise stated.
  • Luminous intensities and color shades of white LEDs may vary within a batch.
  • Luminous intensity will be reduced with lower operating current.